How to make usb to rs232 serial cable

I accidentally deleted all biss key entries. What danger does it pose to my Qsat? Can I recover the deleted pre-loaded biss? Do you have an idea on the problem.

This article came a day late. I just recharged my G6 yesterday at alaba friday and the guy used a laptop to do it and the application used is the same as the pic displayed above. Weeeeeell done I salute your courage. I love this and I have been researching on this thank you for liberating me. Pls how much is the bafo bf adapter? As I write now at least I can talk for Ghana. Qsat is totally down even with CCCam account. Hi lemmy! Was able to troubleshoot the problem by switching off avatarcam and using only cccam account.

Azsky super n qsat not working or showing any channel from yesterday night.. Oga lemmy, how do we get this BAFO-cable? What is the cost? Even though there is partial downtime for dondles. Morning Lemmy, any news on code 42 and 46? Its hurt you know been offline, my code is 42 for Qsat 13G.

Thanks once again. Please update me. Goodmorning lemmy! Please what could be the cause and solution to my qsat q23 g rebooting on its own every minute since this morning. Pls lemmy I will lke 2 knw how much and how do I get it, I stay in Benin city.

Leric1, it is available in popular computer accessory shops. Just make sure you get the original. Your email address will not be published. Notify me of follow-up comments by email. Notify me of new posts by email. Hi, can I modify usb to parallel converter as usb to serial converter? What should I do?? Where can I buy one or how can I place an order for such a device?

You must be logged in to post a comment. Facts about melanoma you should know. Measuring of electrical energy consumption. Log in to Reply. Only patience is required to make these cables; no prior knowledge necessary. It will take around an hour to complete a cable. After a few practice cables, they can be made in 10 to 15 minutes.

With the ability to control devices from a stationary spot, you don't have to worry about searching for a remote or physically pushing buttons on the device. Caution: Make sure to push wires as far back as they will go into the 4-pin wire splicers to ensure a proper signal flow and avoid malfunctioning cables. Usually you should try to match the color of the cables for best appearance. I only had red tape! You now have a hopefully working 9-pin serial to Ethernet cable.

If there is a problem, it usually has something to do with mapping designated pins with correct inner cables.